5 Sided Jewelry Box Pattern
- 0.10 LBS
Make this 5 Sided Jewelry Box Pattern your next scroll saw project. The jewelry box is quite elegant and can be used for a variety of uses.
This 5 Sided Jewelry Box Pattern is actually not too difficult to make. 1/8 inch thick material can be used which allows the use of stacking to save time by cutting parts simultaneously. It measures approximately 8 inches in diameter and 5 inches tall.
Out of plywood: -1/8 Birch plywood is recommended because 8 1/2 inch wide pieces are required. 1 pack should be enough.
Out of hardwood: you will have to glue up 6 inch wide boards for the top and bottom. -3 boards 6 inch wide (1/8 Thick are needed. all boards are 24 inches long) The jewelry box is a tab and slot pattern, so no screws or nails are required. Glue is needed to secure all pieces. No hardware is needed.