Woodworking Materials, Supplies, and Tools from Cherry Tree Toys

General Finishes

General Finishes Sedona Water Based Stain Pint

(No reviews yet) Write a Review
F-3200P Sedona
1.40 LBS
  • This is a sample of the General Finishes Sedona Water Based Stain  on a piece of maple.
  • This is a sample of the General Finishes Sedona Water Based Stain on apiece of oak.

Currently Out of Stock


The Sedona is a water based wood stain that has all the advantages of oil based stains. They spread easily, can be repaired, blend effortlessly and have plenty of open time. The thicker formula allows controlled saturation, which will reduce blotching on softer woods such as Aspen, Pine and Maple. This Sedona interior stain can be applied over existing finishes. Water Based stains are easy to clean up with soap and water, and disposal is just as simple, plus they eliminate fire hazards.

You can apply the stain with a brush, roll, pad, or spray gun. A topcoat is required with high performance clear poly. Normally the dry time is about 30 minutes depending on air moisture. A top coat or re-coat usually takes up to two hours.

General Finish water based stains contain high-quality pigments that produce rich, dark, uniform colors on hard-to-stain woods. This stain has a Low odor, low VOC, water cleanup, and noncombustible which are an environment-friendly and safer for your health.  These stains are now formulated with more than 50% Renewable Resources formulated from sustainable materials that decrease the carbon footprint.

General Finishes is a Wisconsin-based wood coatings manufacturer that was founded in 1928, has been a trailblazer in the water-based technology revolution.

General Finishes Sedona Water Based Stain Pint Specifications:

  • Sedona.
  • Water Based Stain.
  • Pint - 1.40 pounds.
  • Interior Only.
  • 1 + Coats.
  • VOC: 163.466 g/L
  • Applied with a brush, spray, roll, or pad.
  • Spray Tip Size - HVLP 1.1mm-1.3mm.
  • Can be used over other finishes.
  • Dry Time - Raw Wood (30+ minute), Existing Finish (1+ hour).
  • Re-coat Dry Time - 2 hours.
  • Dry Time Over Oil Based Product - 24 hours.
  • Coverage - 50-75 square foot per pint.
View AllClose

Warranty Information

LIMITED WARRANTY: General Finishes products must be tested to your complete satisfaction before using. GF will not be responsible for color satisfaction, misapplication, nor compatibility with other manufacturers’ products. GF will be responsible only for the cost of our products, and not for costs such as labor, damage or project replacement.
View AllClose