Sanderling Cast Feet

Finish your carving of a full size Sanderling a little faster and easier with a pair of the Sanderling Cast Feet.  The Sanderling feet are a pair of (left and right) legs and feet that are cast from pewter using a life like casting to create realistic Sanderling feet.  The feet are easy to slightly move and install.  The pewter paints easily and will make your Sanderling carving a sensation.

Sanderling Cast Feet Specifications:

• Delise Feet originals.
• Made in the USA.
• Sold by the pair. (one left and one right to fit one full size Sanderling).
• Full Size.
• From the tip of the front toe to the tip of the back to is 1 5/16" long.
• From the bottom of the foot to the top of the leg tenon is about 2 1/4" high.
• Each foot is about 15/16" wide.
• There are 4 toes.  Three to the front and one to the back.
• There is a tenon on the bottom of each foot that is about 1/8" in diameter and 3/8" long.  This tenon can be used to mount the bird and feet onto a surface, like a branch or may be clipped off if not needed.
• The top of the leg is about 1/8" in diameter.

Tips For Installing Sanderling Cast Feet:

• Drill holes in the bird to attach the legs and feet. 
• The legs do have a left and a right.  If you look carefully at the top of the leg, they will be marked.  Also remember that the hind toe goes to the inside of the bird.
• Attach the legs using an epoxy.
• If you want to bend the feet or legs, GO SLOW!  Use a hair dryer to heat them and slowly bend them into position.
• You can also use a file and notch them from the under side of the knuckles to bend them around.  Be careful because the Sanderling cast feet are very small and can break easily.
• Reinforce the bent feet with a little super glue or apoxie sculpt.
• To blend the legs from the body of the house wren, use a little Apoxie Sculpt to create a feather formation that looks more natural.
• Clean the legs and feet with vinegar or denatured alcohol before painting them.